Instructions for installation of LED car screen in taxi
Time:2019-01-04
Views:169
1. Determine the hole position of the support
The large bracket is connected to the small bracket on the LED on-board screen through screws of M8*15.The bracket should be 15-20cm away from both sides of LED on-board screen.The upper and lower hole positions are adjusted according to the specific model.
First, install the bracket according to the following position, take it to the car to compare the specific position.
The LED vehicle-mounted screen should be placed on the decorative board at the back of the back seat of the car. The spacing between the LED vehicle-mounted screen and the rear glass should be enough to fit the palm of your hand.As shown in the figure below.Because in the process of driving, LED on-board screen will shake, too close to the car will hit the glass.Ok, let the person outside the window look at the left and right center, mark the position of the bracket.
2. Fix the big bracket
After determining the position of the bracket, remove the LED on-board screen and fix the bracket with the drilling tail wire first.The drilling tail wire shall be fixed in all four holes of the bracket (because specific models will be different, some models need to be drilled with an electric drill, and then fixed with screws. The drilling tail wire and screws shall be purchased separately by customers according to their own models, which is not standard for LED on-board screen).After the bracket is fixed, put the LED on-board screen on the bracket and tighten the screws.
3. LED on-board screen wiring
Two wires come out of the rear window LED on-board screen: one power cord;An alarm line.
The power line is two core black jacket pure anaerobic copper 1 square wire, generally red black or brown blue.Red plus black minus, brown plus blue minus.
Alarm line is two core white line or red black line, direct connection to the alarm connector can be used.
The wiring and wiring of the line shall be completed by a professional mechanic. All the lines on the LED on-board screen shall follow the back seat of the car to the steering wheel.The positive pole of red or brown is connected to the ACC (ignition switch) of the vehicle, and the negative pole of black or blue is directly connected to the iron.
The large bracket is connected to the small bracket on the LED on-board screen through screws of M8*15.The bracket should be 15-20cm away from both sides of LED on-board screen.The upper and lower hole positions are adjusted according to the specific model.
The LED vehicle-mounted screen should be placed on the decorative board at the back of the back seat of the car. The spacing between the LED vehicle-mounted screen and the rear glass should be enough to fit the palm of your hand.As shown in the figure below.Because in the process of driving, LED on-board screen will shake, too close to the car will hit the glass.Ok, let the person outside the window look at the left and right center, mark the position of the bracket.
After determining the position of the bracket, remove the LED on-board screen and fix the bracket with the drilling tail wire first.The drilling tail wire shall be fixed in all four holes of the bracket (because specific models will be different, some models need to be drilled with an electric drill, and then fixed with screws. The drilling tail wire and screws shall be purchased separately by customers according to their own models, which is not standard for LED on-board screen).After the bracket is fixed, put the LED on-board screen on the bracket and tighten the screws.
Two wires come out of the rear window LED on-board screen: one power cord;An alarm line.
The power line is two core black jacket pure anaerobic copper 1 square wire, generally red black or brown blue.Red plus black minus, brown plus blue minus.
Alarm line is two core white line or red black line, direct connection to the alarm connector can be used.
The wiring and wiring of the line shall be completed by a professional mechanic. All the lines on the LED on-board screen shall follow the back seat of the car to the steering wheel.The positive pole of red or brown is connected to the ACC (ignition switch) of the vehicle, and the negative pole of black or blue is directly connected to the iron.
分享
.jpg)
